Show-Me Hydro Clean Guide

Why Is a Concrete Patio Slippery When Wet?

The Short Answer

A concrete patio turns slippery when a thin film of algae, mildew and rotting leaf matter builds up on the surface, and water turns that film into something close to grease. Shaded corners and steps grow it first because they stay damp the longest. Around Wilsons Creek, a professional cleaning treatment kills the growth in the pores of the concrete and rinses it away, so the patio has grip again.

In This Guide

What Makes a Concrete Patio Slick When It Gets Wet?

Usually a living film, not the concrete itself. Algae and mildew settle into the rough surface, and when rain or dew wets them they turn soft and slimy underfoot.

Mold needs very little to get going. The EPA says molds can be found almost anywhere that moisture and oxygen are present, and a patio after a rain has both.

Leaves add fuel. Outdoors, molds break down dead plant matter such as fallen leaves, according to the EPA, so a patio that collects leaf litter every fall also collects the food that keeps the film growing.

Clean, bare concrete has a fine texture that gives shoes something to bite. Once that texture is filled in with green or black growth, the bite is gone.

Fine dust and pollen play a part too. They settle into the same texture and hold a little water after every shower, which gives the film a head start.

Limestone steps before cleaning, concrete cleaning by Show-Me Hydro Clean in Springfield, MO

Why Are Shaded Corners and Steps the Worst Spots?

They stay wet longest. Corners against the house, the strip under a downspout and steps beside shrubs may never fully dry between rains.

Look at where the green shows up. It is rarely the middle of a sunny slab and almost always the edges where shade, runoff and leaves pile up together.

Steps make the problem worse because of what people do on them. Weight shifts forward, hands are full of plates or laundry, and a heel that slides on a damp riser can turn into a hard landing on the edge of the step below.

North-facing patios and slabs under big trees can stay slick for most of the year. Those are the spots that need cleaning first and most often.

In Wilsons Creek and the rest of the Springfield area, the wet months of spring and the leaf drop of fall are when these spots look their worst. That is also when people tend to notice them, usually after a near miss on the steps.

Is the patio slick by the back steps again? Show-Me Hydro Clean handles concrete cleaning and pressure washing in Springfield, gives free written quotes and is fully insured. Call (417) 427-5018 or request a free quote online.

Who Is Most at Risk on a Slippery Patio?

Older family members and young children take the hardest falls. University of Missouri Extension reports that 31% of Missourians age 65 and older say they fall at least once a year.

The cost adds up statewide. MU Extension ties about $900 million in yearly medical costs to falls in Missouri.

Guests are at risk too. A friend who does not know which corner stays green has no reason to slow down, and a patio party after an evening shower is when that matters.

Pets slip on the same film. A dog that bolts out the door onto slick concrete can strain a hip or shoulder in a single bad step.

Why Doesn't a Quick Hose Rinse Fix the Problem?

A rinse knocks loose the top layer but leaves the growth anchored in the pores. Within a few damp weeks the film is back, sometimes looking cleaner while feeling just as slick.

Concrete is full of tiny holes. Algae and mildew root into that texture, so water alone slides over them instead of lifting them out.

Scrubbing with a stiff broom has the same limit. It can lighten the color, yet the living part of the film survives below the surface and regrows as soon as the slab stays wet again.

Some films are not even visible. A patio can look gray and clean yet still feel slick, because a thin layer of growth sits in the texture without much color.

Garage doors and clean concrete driveway of a residential property in Springfield, MO, showcasing the results of professional pressure washing services by Show-Me Hydro Clean.

How Does a Professional Cleaning Remove the Slick Film?

It treats the growth, then lifts it out of the pores with pressure set for concrete. Show-Me Hydro Clean washes driveways, walks and patios and treats mold and mildew along with stains.

Concrete can take more pressure than siding or wood, so the rinse can reach deep into the surface. Even so, the passes stay wide and even to avoid stripes or wand marks on the slab.

The treatment is what changes the result. A cleaning solution reaches the growth hiding in the pores, so when the rinse comes through it carries off the living film and not just the stain on top.

On a patio with a slick film, the crew’s work typically follows this order:

Joints and drains get attention too. Growth packed into control joints feeds the film on both sides of the cut, so those lines are flushed out during the rinse.

Who Cleans Slippery Patios in Wilsons Creek?

Show-Me Hydro Clean cleans patios and steps around Wilsons Creek through its patio and concrete cleaning service. Every quote is free and written for the slab in question.

The area shares its name with Wilson’s Creek National Battlefield, whose Civil War research library opened in 1985 and holds over 12,000 books. Yards out that way often have big trees and open ground nearby, so shaded patios and damp steps are common.

Square footage, how deep the stains and growth go, any sealing added afterward and access to the slab and a water supply set the price. See the Wilsons Creek service page, and if leaves are part of the trouble, read about why fall leaves stain a patio.

Show-Me Hydro Clean usually texts back within minutes, and a written quote tends to follow within 24 hours. Pricing is transparent with no hidden fees.

Frequently Asked Questions

Yes, mostly when algae, mildew or rotting leaves form a film on top. Bare, clean concrete keeps its grip much better than a slab coated in growth.
Shade keeps the surface damp, and algae and mildew grow where moisture and oxygen are present. Corners near downspouts and under trees stay wet longest, so they turn green first.
A proper cleaning does, because it removes the film that makes wet concrete slick. A treatment that kills the growth in the pores keeps it from coming back as quickly.
It can be, depending on the product and its finish. Show-Me Hydro Clean can add sealing after cleaning, so the choice of sealer is worth talking through before it goes on.
Shaded slabs that stay damp may need it every year, often in spring or fall. Sunny patios usually go longer between cleanings.

More From Show-Me Hydro Clean

Residential trash bin cleaning service by Show-Me Hydroclean, Springfield.
Trash Bin Cleaning

Where Does the Dirty Water Go When Trash Bins Are Cleaned?

When a trash bin is hosed out at the curb, the dirty water runs down the driveway and into the street, carrying food scraps, grease and germs with it. In Nixa, city rules treat that kind of runoff as a pollutant that has no business in the storm system. A dedicated bin cleaning trailer keeps the wash work in one controlled place instead of spreading it down the block.

Read the guide »
Show-Me Hydro Clean wash trailer, pressure washing by Show-Me Hydro Clean in Springfield, MO
Pressure Washing

How Much Water Does Pressure Washing Use?

A professional pressure washer moves roughly 4 to 6 GPM, which is close to what an open garden hose pours out. The difference is what that water does: a pressurized stream lifts grime in one pass, so the job finishes sooner and the meter turns for fewer minutes. For homes in Elwood and around Springfield, that usually means a pro wash uses less water than an afternoon with a hose.

Read the guide »
Residential home undergoing soft washing service, with a ladder positioned against the roof, showcasing the cleaning process on one side of the roof, emphasizing eco-friendly maintenance practices for Springfield homeowners.
Roof Washing

Why Is Roof Lichen Harder to Remove Than Moss?

Lichen grips a roof far harder than moss does. Moss hangs on with a shallow root system, but crusty lichen grows right into the granule layer of the shingle and becomes part of the surface. On Springfield roofs, that means lichen needs a low-pressure soft wash and then time to break down, never a scraper or a hard spray.

Read the guide »
Scroll to Top